Measure Data
The acquired data presented here for download, were used to create the Figures
presented in the Measurement Results page.
These measures were taken with HP4195A Network/Spectrum Analyzer.
The files below are in *.csv format and are composed by four columns. The first two columns
represents the magnitude and the other two columns left, are the phase. The data units is
Hz for frequency, dBm for magnitude and Degree for phase.
- Noise PSD Up To 100MHz. (Data from Figure 1)
- Noise PSD Up To 500MHz. (Data from Figure 2)
- Noise PSD With One Amplifier Up to 100MHz. (Data from Figure 3)
- Noise PSD with one Amplifier Up to 500MHz. (Data from Figure 4)
- Measure with different configurations of the spectrum analyzer. (Data from Figure 5)
- Measure with different configurations of the spectrum analyzer and with amplifier. (Data from Figure 6)
- Noise PSD with LC Filter. (Data from Figure 7)
These measures were taken with PicoScope 3206 Digital Storage
Oscilloscope at 200MSamples/sec. The files below are in *.csv format. The data units is
Seconds (s) for time and Volts (V) for voltage.
- Noise Measure with two ZFL-500+ Amplifier. (Data from Figure 9)
- Noise Measure without Amplifier. (Data from Figure 11)
- Comparison of the noise at an House with the noise at Laboratory. (Data from Figure 13)
- Noise Measure with one ZFL-500LN+ Low Noise Amplifier. (Data from Figure 14)
- Comparison of the noise present in different places. (Data from Figure 17)
